MAX IV GT GT-R
Explanation of the product Application chart

GT-R R35
MAX IV GT Code No. 80230-AN001
 
 


▲The above photo is an item for R35.

Awesome control and comfort ride on the street for a sporty drive. The new Max IV sporty suspension.



Application   Specification
Engine VR38DETT
Model Year 16/07 - 
Remarks MY17 Pure edition
 
  FRONT REAR
Damping force adjustment 30 steps 30 steps
Base valve - -
Height adjustable lower bracket
Upper mount Rubber Rubber
Inverted/Normal type Normal Normal
Damper/Spring layout Coilover Coilover
Spring rate change at factory Possible Possible
Damping force adjustment with wire -
Helper spring
(Spring rate N/mm)
○ ( 19.8 ) ○ ( 19.8 )


Ride Height mm
  Factory *2 Test data Adjustable range
High - Low *3
Drivable range
High - Low *4
FRONT Ride height *1 714 705 719 ~ 637 719 ~ 649
Against stock -5 -14 0 ~ -82 0 ~ -70
REAR Ride height *1 727 714 728 ~ 670 728 ~ 693
Against stock -1 -14 0 ~ -58 0 ~ -35
*1. Height from road surface to fender arch.
*2. Height at factory is the data tested at HKS with the setting of Full Kit. (HKS' recommended setting.)
*3. Adjustable range (However, the lowest value may not be road legal.
Even within the adjustable range, car body, arm etc. may contact. In such case, it will be hard to drive.
Damper oil leakage or any other problems caused by low ride height setting from the factory setting will void the warranty of the product.)
*4. Drivable range that there is no contact of car body or arms etc. (However, change of tire/wheel size may cause a problem.)
Caution). Actual data depends on each vehicle.


Kit information
Spring of Full Kit
  F R
Spring rate N/mm(kgf/mm) 157 ( 16 ) 78 ( 8 )
Free height (mm) 200 250
Spring type Straight Straight
Recommended range to change spring rate N/mm(kgf/mm) ±20 ( 2 ) ±20 ( 2 )
Specification of damper
  F R
Damping force (Rebound/Damping)N* 1300 / 250 700 / 160
Default position of dial 15 15
Remaining damper stroke (Rebound/Damping)mm 42 / 58 84 / 86
* The value of the damping force is at piston speed of 0.1m/sec.
Setting data
  F R
Default Test Drivable limit
High *
Drivable limit
Low *
Default Test Drivable limit
High *
Drivable limit
Low *
Length of
case (mm)
474 477 477 477 417 405 418 392
Spring
Set length(mm)
225 235 224 274 318 318 324
Length to ride hight
adjuster (mm)
65 58 69 19 51 39 52 20
Lever ratio 1.43 1.15
* Refer to the above explanation *3 of ride height information for drivable high and low limitations.


Test vehicle information
  F R
Vehicle weight kg 978 807
Tire size (Air pressure) kPa 255 / 40 - 20 ( 210 ) 285 / 35 - 20 ( 200 )
Wheel size 9.5 JJ × 20 inset 45 10.5 JJ × 20 inset 25
Alignment
(Toe/Camber)
Test data in 1 mm / -1°30' in 2 mm / -2°00'
Standard value - -
* Test data at HKS.


Parts List * It may be changed without prior notice.


Point
・HKS has set the MAX IV for both sportiness and comfort.
・We haven't spoiled stock's sportiness and improved the comfortable drive and also provides better control.
・We have improved the driving experience drastically compared to the old model by analyzing year 2012 model and VPS and new piston.
・We have improved driving performance of road-hugging property by high-rate + helper-spring. And improving the start-up damping allow comfortable drive and keep down the sudden pressure change.
・Set about 20th step for a comfort drive and about 5th step for a fast drive.
・If the length of case shortens below the lower limit value, it is likely to interfere with the upper arm and body. Also depend on the size of the tire wheel, it could interfere with fender even within the limits.
 
 
 
 
 


[ CLOSE ]

 

 

HKS